1. Manuals
  2. Brands
  3. ASGCO Manuals
  4. Industrial Equipment
  5. U-Scrape
  6. Installation, operation, & maintenance instruction

ASGCO U-Scrape Installation, Operation, & Maintenance Instruction

With bolt-up tensioner system
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

U-Scrape™
with Bolt-Up Tensioner System
INSTALLATION, OPERATION
& MAINTENANCE INSTRUCTION
Need Solutions...
www.asgco.com
|
800.344.4000
© 4/2021 Copyright ASGCO "Complete Conveyor Solutions"
to improve efficiency, safety and productivity?
| info@asgco.com| EM:
610.821.0210
ask... ASGCO
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the U-Scrape and is the answer not in the manual?

Questions and answers

Related Manuals for ASGCO U-Scrape

Summary of Contents for ASGCO U-Scrape

  • Page 1 U-Scrape™ with Bolt-Up Tensioner System INSTALLATION, OPERATION & MAINTENANCE INSTRUCTION Need Solutions... ask... ASGCO ® to improve efficiency, safety and productivity? www.asgco.com 800.344.4000 | info@asgco.com| EM: 610.821.0210 © 4/2021 Copyright ASGCO “Complete Conveyor Solutions”...

  • Page 2: Safety First

    Failure to observe all instructions could result in serious injury. It is the owner’s responsibility that the owner and each operator read and be familiar with this manual. Please contact our ASGCO engineering Department at 1.800.344.4000 if you have further questions or are unsure of these procedures.
  • Page 3 XX - BELT WIDTH OVERALL VIEW The U-Scrape is a Secondary Belt Cleaner designed to be installed on the return side of the belt. Identify and become familiar with all the parts. Ensure all parts have been included. If mounting structure is not available, additional steel may have to be added.

  • Page 4: Mounting Bracket

    DETERMINE CLEANER LOCATION The U-Scrape™ is a Secondary Cleaner and as such should be located on the return side of the belt after the belt leaves the head pulley as shown below. Preferably not much further from the confines of the head or dribbled chute.
  • Page 5 Bushing Adj. Angle Spring Plates Bushing Adj. Angle Bolt-Up Bracket Step 2 Hang the U-Scrape with its tube on the bush- ing adj. angles, and slide on the 2 each tube bushings. U-Scrape with Tube Tube Bushing Bushing Adj. Angle Tube Bushing Bushing Adj.

  • Page 6: Operation

    Step 5 With an extra hand, have someone push the U-Scrape cleaner up against the belt. Install both springs, move the power arms downward until there is some tension on the springs and Spring tighten the set screws on the power arm.

  • Page 7: Maintenance

    Inspect the belt surfaces and edges for cracks, splits, tears, holes or any other worn or damaged condition occurring on the surfaces or edges of the belt itself. If necessary make repairs to the belt. RE-TENSIONING OF U-SCRAPE™ CLEANER •...

Table of Contents