Epson Stylus CX3200 Start Here

Start Here
1
Unpack
1
Make sure you have all the parts shown here. If any parts are missing,
contact EPSON as described on the back of this sheet.
Stylus CX
Paper support USB cable Software Booklet
CD-ROM
Ink cartridges Feeder guard
2
Remove any tape and packing materials, as shown.
Do not remove
this sticker yet
Note: There may be additional packing materials or tape in
locations different from the ones shown here. Do not remove
the sticker covering the USB port yet.
2 2
Unlock
1
Open the scanner lid, as shown. Remove any packing materials
under the lid.
continue
EPSON Stylus CX3200
®
continued
2
Slide the transportation lock back to the
3
Close the scanner lid.
3
Attach the Parts
1
Insert the paper support into its three slots.
2
Snap the feeder guard into its two slots in the sheet feeder.
4
Plug In
1
Plug the Stylus CX into a grounded electrical outlet.
Do not connect the USB cable yet.
5
Install Ink Cartridges
1
Lift up the scanner.
unlock position.
2
Peel off the tape and remove the plastic piece from the
ink cartridge holder.
3
Press and hold the On button for 2 seconds. The green light flashes
and the scanner carriage and print head move.
Press the
On button
4
Unwrap the ink cartridges and remove the yellow tape.
5
Lift up the ink cartridge clamps.
6
Insert the ink cartridges with the labels face-up.
continued
7
Press down the ink cartridge clamps until they snap shut.
8
Carefully lower the scanner back down into place. The Stylus CX
begins charging the ink delivery system.
1
Charging takes about 1 / 2 minutes. The green light flashes and the
Stylus CX makes various sounds. Don't turn it off while the green
light is flashing or you'll waste ink.
Caution: You must install both cartridges and leave them installed
for all types of printing. To avoid damaging the Stylus CX, never
move the print head by hand.
6
Load Paper
1
Flip the feeder guard forward.
2
Place a stack of paper against the right side of the feeder, beneath
the tab. Pinch the left edge guide and slide it against the paper.
Caution: Make sure you load paper behind the feeder guard.
3
Flip the feeder guard back over the stack of paper.
4
Position the Stylus CX so the front is at least 9 inches
from the edge of the table.
continue
Turn over
Open the output tray and
pull out the extension