Electrolux ERW1170AO User Manual page 12

12 electrolux
WHAT TO DO IF...
Warning: Before troubleshooting,
disconnect the power supply. Only a qualified
electrician of competent person must do the
troubleshooting that is not in this manual.
Malfunction
The wine is too warm.
Interior lighting does not work.
Heavy build up of the frost,
possibly also on the door seal.
Unusual noises.
The compressor does not start
immediately after changing the
temperature setting.
Water on the floor.
ENVIRONMENTAL CONCERNS
The symbol on the product or on its
packaging indicates that this product may not
be treated as household waste. Instead it shall
be handed over to the applicable collection
point for the recycling of electrical and electronic
equipment. By ensuring this product is disposed
of correctly, you will help prevent potential
negative consequences for the environment and
normal use (compressor, refrigerant circulation).
Possible cause
Temperature is not properly
adjusted.
Door was open for an extended
period.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air tight (possibly
after changing over the hinges).
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
rear of the appliance is touching
another part of the appliance or
the wall.
This is normal, no error has
occurred.
Water drain hole is blocked.
human health, which could otherwise be caused
by inappropriate waste handling of this product.
For more detailed information about recycling of
this product, please contact your local city office,
your household waste disposal service or the
shop where you purchased the product.
Important: There are some sounds during
Remedy
Please look in the "Use" section.
Open the door only as long as necessary.
Please look in the "Installation" section.
Please look in the "Maintenance" section.
Carefully warm the leaking sections
of the door seal with a hair dryer (not
hotter than approx. 50 °C). At the same
time shape the warmed door seal by
hand such that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
The compressor starts after a period of
time.
See the "Cleaning" section.