Filling The Heating System On The Heating Water Side; Shutting Down The System - Viessmann Vitoladens 300-T Service Instructions For Contractors

Filling the heating system on the heating water side

Fill water
According to EN 1717 with DIN 1988-100, as a heat
transfer medium for DHW heating, the heating water
must meet fluid category ≤ 3. This requirement is met if
water of potable quality is used as heating water. For
example, if additives are used, the additive manufac-
turer must specify which category the treated heating
water comes under.
Total permissible hardness of the fill and top-up water
Total heating output
kW
50
≤
50 to 200
> ≤
200 to 600
> ≤
600
>
B
Fig. 1
1. Close shut-off valve
B
2. If using a top-mounted Divicon (accessories):
Set the mixer lever to "OPEN" (red).

Shutting down the system

Specific system volume
< 20 l/kW
3
3.0 mol/m (16.8 °dH)
≤
3
2.0 mol/m (11.2 °dH)
≤
1.5 mol/m 3 (8.4 °dH)
≤
3
< 0.02 mol/m (0.11 °dH)
A
in the return line.
Commissioning, inspection, maintenance
!
Please note
Unsuitable fill water increases the level of
deposits and corrosion and may lead to appli-
ance damage.
■ Flush the heating system thoroughly before
filling.
Only use fill water of potable water quality.
■
Special antifreeze suitable for heating systems
■
can be added to the fill water. The antifreeze
manufacturer must verify its suitability.
■ Fill and top-up water with a water hardness in
excess of the following values must be soft-
ened, e.g. with a small softening system for
heating water.
20 l/kW to < 50 l/kW
≥
3
2.0 mol/m (11.2 °dH)
≤
3
1.5 mol/m (8.4 °dH)
≤
0.02 mol/m 3 (0.11 °dH)
≤
3
< 0.02 mol/m (0.11 °dH)
3. Fill the system via fill valve
return until it is fully vented.
4. Reopen shut-off valve
50 l/kW
≥
3
< 0.02 mol/m (0.11 °dH)
3
< 0.02 mol/m (0.11 °dH)
< 0.02 mol/m 3 (0.11 °dH)
3
< 0.02 mol/m (0.11 °dH)
A on the heating water
.
B
9