Table of Contents
Advertisement
11
C
2: I
HAPTER
NSTALLING THE
Observing Safety
Precautions
E
A
THERNET
DAPTER
Figure 3 shows
the front view of the Ethernet Adapter, including
connecting ports. It also shows the cradle, which is used to mount the
Ethernet Adapter to a wall or to install the Ethernet Adapter on a flat surface.
Figure 3 Ethernet Adapter
802.11a/b/g Wireless
Ethernet Adapter
Power Port
Serial Port
Ethernet Port
This equipment must be installed in compliance with local and national
building codes, regulatory restrictions, and FCC rules. For the safety of
people and equipment, only professional network personnel should
install the Ethernet Adapter.
WARNING: To comply with FCC radio frequency (RF) exposure limits, a
minimum body-to-antenna distance of 20 cm (8 in.) must be maintained
when the Ethernet Adapter is operational.
WARNING: To avoid possible injury or damage to equipment, you must
use either the provided power supply or power supply equipment that is
safety certified according to UL, CSA, IEC, or other applicable national or
international safety requirements for the country of use. All references to
power supply in this document refer to equipment meeting these
requirements.
WARNUNG: In Übereinstimmung mit den von der FCC (Federal
Communications Commission) festgelegten Grenzwerten für die
Einwirkung von Radiowellen muss bei Betrieb des Ethernet-Adapters der
Abstand zwischen Körper und Antenne 20 cm betragen.
WARNUNG: Zur Vermeidung möglicher Verletzungen oder Schäden am
Gerät muss entweder das mitgelieferte Netzteil oder ein Netzteil
verwendet werden, das von der UL (Underwriters Laboratories Inc.), CSA
the LEDs and
Advertisement
Table of Contents
