Audio Settings; System Settings - Pioneer DEH-S1153UB Owner's Manual

AUDIO settings

Menu Item
FADER*1*2
BALANCE
EQ SETTING
[SUPER BASS], [POWERFUL],
[DYNAMIC], [NATURAL], [VOCAL],
[VIVID], [CUSTOM1], [CUSTOM2],
[FLAT]
Select an equalizer band and
level for further customizing.
Equalizer band: [80HZ], [250HZ],
[800HZ], [2.5KHZ], [8KHZ]
Equalizer level: [+6] to [–6]
LOUDNESS
[OFF], [LOW], [MID], [HI]
SUB.W*3*4
[NOR], [REV], [OFF]
SUB.W CTRL*3*4*5
Cut-off frequency: [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Output level: [–24] to [+6]
Slope level: [–12], [–24]
BASS BOOST
[0] to [+6]
HPF SETTING
Cut-off frequency: [OFF], [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Slope level: [–12], [–24]
SLA
[+4] to [–4]
Description
Adjust the front and rear speaker balance.
Adjust the left and right speaker balance.
Select or customize the equalizer curve.
[CUSTOM1] can be set separately for each source.
However, each of the below combinations are set
to the same setting automatically.
[CUSTOM2] is a shared setting used for all
sources.
You can also switch the equalizer by pressing
repeatedly.
Compensate for clear sound at low volume.
Select the subwoofer phase.
Only frequencies lower than those in the
selected range are output from the subwoofer.
Select the bass boost level.
Only frequencies higher than the high-pass filter
(HPF) cutoff are output from the speakers.
Adjust the volume level for each source except
FM.
*1 Not available when [SW] is selected in [REAR-SP] in the INITIAL settings (page 5).
*2 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*3 Not available when [FUL] is selected in [REAR-SP] in the INITIAL settings (page 5).
*4 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*5 Not available when [OFF] is selected in [SUB.W].

SYSTEM settings

You can also access to these menus when the unit is turned off.
Menu Item
CLOCK SET
12H/24H
[12H], [24H]
SCROLL SET
[ONCE], [LOOP], [OFF]
AUTO PI
[ON], [OFF]
AUX
[ON], [OFF]
ANDROID WIRED
[MEMORY], [APP CONTROL]
P.APP AUTO ON
[ON], [OFF]
S.REMOTE*1*2
[OFF], [PIONEER], [PRESET]
Description
Set the clock (page 4).
Select the time notation.
Select the way to scroll the text in the display
window.
Search for a different station with the same
programming, even if using a preset station.
Set to [ON] when using an auxiliary device
connected to the unit.
Select the appropriate connection method for an
Android device.
Select [ON] to automatically launch Pioneer ARC
APP when an Android device is connected to the
unit via AOA. (Not available when [MEMORY] is
selected in [ANDROID WIRED].)
Select [PIONEER] or [PRESET] according to your
wired remote control.
9
En