Maintenance - MULTIQUIP MIX N' GO MC3SE Operation And Parts Manual

Mini concrete mixer
Hide thumbs Also See for MIX N' GO MC3SE:
Table of Contents

Advertisement

Maintenance

Gearbox Oil Check
1. Position the mixer on a level surface and place a support block
under the front of the mixer frame as shown in Figure 29. This
will level the mixer.
2. NEVER! check the gearbox oil level with the mixer tilted up or
down. ALWAYS check the gearbox oil level with the mixer in a
level position.
Figure 29. Mixer Positioning (Gearbox Oil Level)
CAUTION :
Check the gearbox oil level monthly
before operating mixer. Low oil level or no
oil will severely damage gearbox.
3. Before inspecting the gearbox oil level, make sure the gearbox
is cold before removing the filler plug. Hot! oil can burn skin and
cause injury. Let oil cool before checking.
4. Remove gearbox oil filler plug (Figure 30) and fill with EP90 or
similar gear oil to the level of the filler plug. Replace gearbox oil
every 3,000 hours. Gerabox oil capacity is 8-10 ounces .
MIX N' GO MIXER — OPERATION & PARTS MANUAL — REV. #5 (11/07/05) — PAGE 25
MIX N' GO MIXER — MAINTENANCE
5. Insert oil filler plug and tighten.
Figure 30. Gearbox Oil Level Check
V-Belt Check
1. To adjust V-belts, remove V-belt cover and loosen the main
motor mount bolts (Figure 31), raise electric motor and
retighten bolts. Belt tension should be adjusted so that the
maximum deflection is approximately 3/8 inch (10 mm).
2. Replace V-belt cover.
Figure 31. V-belt Adjustment
Gerarbox Removal
1. Remove drum by turning counter-clockwise to release from
gearbox shaft.
2. Remove pulley, remember the nut securing the pulley is
left-hand threaded. Remove circlip, and draw out shaft.
3. Remove the 5 bolts securing rear plate.
4. Reassemble in reverse order, taking care to ensure gear teeth
are meshed correctly.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mix n' go mc3sMix n' go mc3peMix n' go mc3p

Table of Contents