Table of Contents
Advertisement
2) Remove the wiring screws on the terminal board.
3) Shape the tail of wire into ring by needle nose plier, and keep the gauge of ring in
accordance with screw.
4) Use the screwdriver for tightening the terminal.
(2) The connection of stranded wire (as shown in fig 5.1.2)
1) Strip about 10mm (3/8 in.) insulation of the end of stranded wire by stripping and
cutting tool.
2) Loosen the wiring screws on terminal board.
3) Insert the wire into the ring tongue terminal and tighten by crimping tool.
4) Use the screwdriver for tightening the terminal.
5.2 Power Cord Connection
NOTICE!
Every unit should be equipped with a circuit breaker for short-circuit and overload protection.
During operation, all indoor units connected to the same outdoor unit system must be kept
energized status. Otherwise, the unit can't operate normally.
For units with single-phase power supply.
(1) Detach the electric box lid.
(2) Let the power cord pass through the wiring through-holes.
(3) Connect the power cord to terminal "L1, L2, ".
(4) Fix the power card with wiring clamp.
(5) The wire diameter of power cord can't be less than 18AWG.
Multi Variable Air Conditioners Ducted Type Indoor Unit
Fig 5.1.1
Fig 5.2
Fig 5.1.2
16
Unit: mm/in.
Advertisement
Table of Contents
