Table of Contents
Advertisement
3.1 - General
Boiler installation shall be completed by qualified agency.
WARNING
!
Fire, explosion, asphyxiation and electrical shock
hazard� Improper installation could result in death
or serious injury� Read this manual and understand
all requirements before beginning installation�
WARNING
!
Modification, substitution or elimination of factory
equipped, supplied or specified components could
result in death or serious injury�
WARNING
!
Installation or venting a boiler or any other oil
appliance with improper methods or materials may
result in serious injury or death due to fire or to
asphyxiation from poisonous gases such as carbon
monoxide which is odorless and invisible�
Become familiar with symbols identifying potential
hazards.
This is the safety alert symbol� Symbol alerts you to
potential personal injury hazards� Obey all safety messages
following this symbol to avoid possible injury or death�
DANGER
!
Indicates a hazardous situation which, if not
avoided, WILL result in death or serious injury
WARNING
!
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury�
CAUTION
!
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury�
NOTICE
Used to address practices not related to personal
injury�
3 - SAFETY INFORMATION
Construction materials of appliance and products
of combustion and fuel contain alumina, silica,
heavy metals, carbon monoxide, nitrogen
oxides, aldehydes and /or other toxic or harmful
substances which can cause death or serious injury
and which are known to the State of California to
cause cancer, birth defects and other reproductive
harm� Always use proper safety clothing,
respirators and equipment when servicing or
working nearby the appliance�
3.2
authority having jurisdiction or in absence of such
requirements to ANSI/NFPA 31, "Installation of Oil
Burning Equipment". In Canada, Current Edition
of Canadian Standards Association CSA B139,
Installation Code for Oil Burning Equipment" for
recommended installation practices. Such applicable
requirements take precedence over general
instructions of this manual.
3.3
Standard ANSI/NFPA 211 "Chimneys, Fireplaces,
Vents and Solid Fuel Burning Appliances" for
venting.
3.4
jurisdiction, installation shall conform to
Standard for Controls and Safety Devices for
Automatically Fired Boilers, ANSI/ASME CSD-1.
Additional manual reset low water cutoff and manual reset
high limit may be required�
3.5
Massachusetts:
Boiler installation must conform to Commonwealth of
Massachusetts code 248 CMR which includes but is not
limited to: Installation by licensed plumber or gas fitter.
4
WARNING
!
- Installation shall conform to requirements of
- Current Edition of American National
-
Where required by authority having
- Requirements for Commonwealth of
PN 240012628, Rev. A [09/30/2019]
Advertisement
Table of Contents
