Electrolux EW6T4722AF User Manual page 26

26 www.electrolux.com
13.1 Introduction
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists,
contact the Authorised Service Centre.
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
alarm code and the Start/Pause
• - The mains supply is unstable. Wait until the mains supply is stable.
• - No communication between electronic elements of the appliance. Switch it
off and switch on again. The programme was not finished properly or the appliance
stopped too early. If the alarm code appears again, contact the Authorised Service
Centre.
• - The anti-flood device is on. Disconnect the appliance and close the water
tap. Contact the Authorised Service Centre.
• - The appliance does not fill with water properly. After the proper check, start
the appliance again by pressing Start/Pause
resume the cycle . If the error persists the alarm code will appear again.
• - The appliance drum doors are open or not closed correctly. Please close
drum doors !
• - The appliance does not drain the water.
• - The appliance lid is open or not closed correctly. Please check the lid!
13.2 Possible failures
Problem
The programme does
not start.
button may flash continuously:
Possible solution
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that the appliance lid and drum door are
closed.
• Make sure that there is no damaged fuse in the fuse
box.
• Make sure that the Start/Pause
• If the delay start is set, cancel the setting or wait for the
end of countdown.
• Deactivate the Child Lock function if it is on.
• Check the position of the knob on the selected pro‐
gramme.
button the appliance tries to
has been touched.