Advertisement
FreeLINK Wireless LAN System
Installation Procedure for Experienced Users
This installation procedure assumes that you know the
technical characteristics of your computer and your Ethernet
802.3 network. Section numbers refer to the relevant sections of
the FreeLINK Wireless LAN Installation Guide P/N 9030833.
Graphics of wiring connections and connector locations for
Transceiver/Interface Unit and Wireless Hub are shown
throughout this procedure. To install the FreeLINK system,
follow these steps:
STEP 1 - Identify the system components.
Unpack the Wireless LAN System and identify the Wireless
Hub, Wireless Hub antenna, Wireless Transceivers, and
Interface Units. You will install the Wireless Transceivers
and Interface Units Þrst. Figure 1 shows the Wireless
Transceiver/Interface Unit.
FLIU-8 Multi-User
AC Power Cord
Interface Unit
10BASE-T
Ports
Figure 1. Wireless Transceiver and Interface Unit
QUICK START
QUICK START
Signal
Quality
Transmit
Link
Antenna
Cable
LED
Indicators
FreeLINK
Wireless Transceiver
Serial Number
on bottom of antenna
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Enterasys FLIU-1
Summary of Contents for Enterasys FLIU-1
- Page 1 FreeLINK Wireless LAN System Installation Procedure for Experienced Users This installation procedure assumes that you know the technical characteristics of your computer and your Ethernet 802.3 network. Section numbers refer to the relevant sections of the FreeLINK Wireless LAN Installation Guide P/N 9030833. Graphics of wiring connections and connector locations for Transceiver/Interface Unit and Wireless Hub are shown throughout this procedure.
- Page 2 Ethernet adapters in the workstations. Plug the Wireless Transceiver power cable into a 110 volt AC outlet. Power Connection (on rear panel) RJ-45 ports Twisted Pair Figure 3. Wireless Transceiver Interface Unit Use these six digits FLIU-1 RJ-45 Cable FLIU-8 Antenna Antenna Cable...
- Page 3 STEP 3 - Backup and configure system software. Ref. Section 3.1 Make a backup copy of the Cabletron software diskette. Insert this diskette into a PC, type SETUP <Enter>, and follow the conÞguration screens. Use Page Up and Page Down to move between screens. Detailed instructions are outlined in Chapter 3.
- Page 4 80 Meter Radius Figure 5. Wireless Hub Antenna Orientation STEP 6 - Orient workstation transceivers and check for links. Ref. Section 2.10 Orient the workstation transceivers for maximum signal strength (max number of yellow LEDs lit), and check solid green LINK LED for Link Status. See Figure 6, below. Indicators Figure 6.
Need help?
Do you have a question about the FLIU-1 and is the answer not in the manual?
Questions and answers