Table of Contents
Advertisement
1
FO R SAF E INSTALL ATIO N WOR k
1.1 CAuTIONS REgARdINg INSTALLATION OF SOLAR POWER SySTEMS
This manual contains critical information regarding
electrical and mechanical installation and safety
information which you should know before starting
installation.
The information in this manual is based on Sharp's
knowledge and experience, however, the information
and suggestions do not constitute a warranty.
Sharp Electronics Corporation reserves the right to make
changes to the product, specifications, or manual without
prior notice.
Do not locate systems near coastal locations or other
salt water locations or C5 locations as classified by ISO.
Minimum distance is 0.3 miles from the body of water.
Do not locate in a corrosion prone area. The modules
and system are UL listed to standard 1703. The UL 1703
test is performed at 1.5 times the design load of 30 lbs
per square foot, or 45 lbs per square foot. The system has
been load tested by Sharp to 50 PSF. Building departments
often require a design safety factor of 1.5 or greater for
structures. The maximum structural loading listed in this
guide does not include an added safety factor. Check with
your local building department for code information.
CAUTION
Do not drill holes in frame.
1
Do not cut or modify parts or rails.
Work under dry conditions with dry tools.
Do not stand or step on solar module.
Do not install near flammable gases.
4
Do not drop or allow objects to fall onto module.
5
Completely cover solar module with opaque materials
6
when wiring to halt production of electricity.
Keep the back side of solar module surfaces free of
7
foreign objects.
Do not use chemicals on solar modules when
8
cleaning.
Do not wear metallic jewelry, which may cause
9
electrical shock.
Do not touch cable electrical contacts.
10
Do not expose solar modules to sunlight that is
11
concentrated with mirrors, lenses or similar means.
Consult local codes and other applicable laws and
1
statutes concerning required permits and regulations
concerning installation and inspection requirements.
Install solar modules and systems according to
applicable codes.
Solar modules should be installed and maintained by
1
qualified personnel. Keep unauthorized personnel
away from solar modules.
Avoid shadowing cells in order to prevent solar
14
module hot spots and/or reduction in power.
Avoid installing modules and mounting system in
15
high corrosion areas.
6
Cover solar module during
installation to reduce shock hazard
Keep foreign objects away
from solar module surface
Advertisement
Table of Contents
