Before Washing For The First Time; Transportation - Bosch WAW32640EU Instruction Manual And Installation Instructions

Positioning and connecting
en
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from the test, run the first wash cycle
without any laundry.
Notes
The washing machine must be
■
correctlyinstalled and connected.
(from ~ Page 44).
Never use a damaged machine.
■
Inform your customer services.
Preparatory work:
Check the machine.
1.
Fill the ß and i dispensers.
2.
~ Page 28
Remove the protective film from the
3.
control panel.
Connect the mains plug.
4.
Turn the tap on.
5.
Run the programme without laundry.
Switch on the appliance.
1.
Close the door (do not load any
2.
laundry).
Set the Drum Clean 90 °C
3.
programme.
Open the detergent drawer.
4.
Pour approx. 1 litre of water into
5.
compartment v u.
Pour standard detergent into
6.
compartment v u.
To prevent foaming, only use
Note:
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
designed for woollens or delicates.
Close the detergent drawer.
7.
Press the A button.
8.
Switch off the appliance at the end of
9.
the programme.
Your washing machine is now ready to
use.
50

Transportation

E.g. when moving house
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers.
Leaking detergent/fabric softener can
prevent the appliance from working
correctly, e.g. due to damage to the
electronics.
Empty the dispensers before
transporting the appliance.
Preparatory work:
Turn off the tap.
1.
Reduce the water pressure in the
2.
supply hose: ~ Page 37; cleaning
and maintenance – filter in the water
supply clogged
Disconnect the washing machine
3.
from the mains.
Drain any residual water:
4.
~ Page 36; cleaning and
maintenance – drain pump blocked,
emergency draining
Remove the hoses.
5.
Empty the dispensers. ~ Page 34
6.