Getting Started; Initial Setup; Battery Removal And Installation - LeapFrog LeapLand Adventures Parents' Manual

GETTING STARTED

INITIAL SETUP

For your child's safety, the following steps must be assembled by an adult.
1. Plug the USB B Connector end of the Micro USB
Power Cable into the USB B port on the HDMI
Game Stick.
2. Plug the HDMI Game Stick into an HDMI port on
your television.
3. Plug the USB A Connector end of the Micro USB
Power Cable into a USB port on your television
or other qualified DC 5V adapter with output no
less than 500mA.
Note: If the HDMI Extender Cable is needed, plug the HDMI Game Stick
into the HDMI Extender Cable. Plug the HDMI Extender Cable
into an HDMI port on your television.

BATTERY REMOVAL AND INSTALLATION

1. Find the battery cover located on the back of the
Wireless Controller, use a coin or screwdriver to
loosen the screw and then open the battery cover.
2. Remove old batteries by pulling up on one end
of each battery.
3. Install 2 new AA (AM-3/LR6) batteries following
the diagram inside the battery box.
4. Replace the battery cover and tighten the screw
to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
3