Table of Contents
Advertisement
Washing programmes*
*depends on the model
Drying programmes
Special programmes
Q Shirts/Business
Non-iron shirts made of cotton, linen, synthetic fibres or blended fabrics.
Gentle spin only, hang up dripping wet.
J Night wash
Particularly quiet wash programme with a reduced final spin.
Sleep mode. Once the programme has finished, the display goes out, but
can be reactivated by pressing any button.
ˆ Intensive Dry
Intensive drying for a (robust fabrics), at 90°C.
‰ Low Heat Dry
Gentle drying for ` (easy-care fabrics), 60°C.
7 Fluff Clean
The drum must be empty.
This programme is designed to clean the drying cycle of any fluff
deposits. The washer-dryer uses the flashing symbol
cycle) in the display panel to show that this programme must be run. The
electronic cycle counter is then automatically reset. The
cycle) symbol goes out after the programme starts.
To run the Fluff removal cycle, proceed as follows:
Make sure that the drum is completely empty and close the door.
Set the programme selector to
Press the ! (Start/Pause) button.
The
(Fluff-removal cycle) programme can also be run at any time
7
without prompting by the appliance.
Rinse ' + Spin
0:
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the Spin speed to $ (Rinse hold) before Programme
start –> page 16.
+
Empty
+ Spin
Drain the rinsing water following a programme with
$ (Rinse hold) –> page 16.
Turn the programme selector to Empty
Set the Spin speed to $ (Rinse hold).
Press the ! (Start/Pause) button.
or
Drain and spin at the desired spin speed:
Turn the programme selector to Empty
Press the 0 Spin button repeatedly until the desired spin speed is set.
Press the ! (Start/Pause) button.
7
(Fluff-removal cycle).
0:
+
+
(Fluff removal
7
(Fluff removal
7
+ Spin 0.
+ Spin 0.
15
Advertisement
Table of Contents
