Cold Check Procedure - Cadillac 2008 Escalade EXT Owner's Manual

5. Keep the engine running and press the Trip/Fuel
button or trip odometer reset stem until TRANS
TEMP (Transmission Temperature) displays on the
Driver Information Center (DIC).
6. Using the TRANS TEMP reading, determine and
perform the appropriate check procedure. If the
TRANS TEMP reading is not within the required
temperature ranges, allow the vehicle to cool,
or operate the vehicle until the appropriate
transmission fluid temperature is reached.

Cold Check Procedure

Use this procedure only as a reference to determine if
the transmission has enough fluid to be operated
safely until a hot check procedure can be made. The
hot check procedure is the most accurate method
to check the fluid level. Perform the hot check procedure
at the first opportunity. Use this cold check procedure
to check fluid level when the transmission temperature is
between 80°F and 90°F (27°C and 32°C).
1. Locate the transmission dipstick at the rear of
the engine compartment, on the passenger side
of the vehicle.
2. Flip the handle up, and then pull out the dipstick
and wipe it with a clean rag or paper towel.
3. Install the dipstick by pushing it back in all the way,
wait three seconds, and then pull it back out again.
4. Check both sides of the dipstick, and read the lower
level. Repeat the check procedure to verify the
reading.
The dipstick handle has
this graphic. See Engine
Compartment Overview
on page 5-12 for more
information.
5-21