Jarv POD1605 User Manual

POD1605
Device Overview
Rear Side
Clip
LOGO Side
Installation
1a
Use clip
This device can be clipped onto shirt pocket, collar or
around waist. Please make sure the device is securely
snapped into the clip before use.
1b
Install the sensor on top of Sneakers
When the device is tightened on the shoelace, make sure the LOGO side faces up, while
the shoelace should be pulled through the two shoelace holes aside the device and tied
with a knot to fasten the device.
1c
Install Device into the Slot of the Sneaker
Foot Pod Sensor
LOGO Side
POD1605
Shoelace Hole
Insulation Sheet
Install & Uninstall Clip
To install the clip, slide the clip forward along
the back of the sensor until the sensor is
securely snapped into the clip latch.
LOGO side facing down
Excessive tilting
Battery Cover
The device comes with a battery
pre-inserted. Before using the device, the
insulation sheet must be removed in order
to use the device.
Screw
Please remove the insulation sheet as
shown in the image illustrated. (Improper
removal of the insulation sheet might end
up breaking the insulation sheet.) Once the
battery fails to activate, you will need to
open the battery cover, and remove scraps
of the broken sheet.
While tying the shoelace, pull one through
from upward while the other from
downward, and make sure the LOGO side
faces up.
Please try to keep the device at horizontal
level, for excessive tilting might cause
incorrect detection.
This device can also be installed in shoes that come with
insertion slot for this sensor, such as Nike or Adidas shoes with
special feature marks.
(Lift up sock liner and insert this sensor into the slot with LOGO
facing up)
User Manual
Important Notice
Insulation Sheet
To detach the clip from the sensor,
pull up the clip latch in order to
eject the sensor.
Important Notice
EN