Changing The Programme; Cancel The Programme; Programme End During Rinse Hold; Programme End - Bosch WAK20261IL Instruction Manual And Installation Instructions

Operating the appliance
en
A flashing NO symbol, wait until YES
■
and ¼ light up.
Do not open the door until both the
YES and the ¼ symbols are lit.
A flashing NO symbol, it is not
■
possible to add laundry.
For safety reasons, the washing
machine door remains locked when
the water level or temperature is
high, or while the drum is rotating,
and it is not possible to add laundry.
To continue the programme, press
the Start/Pause button. The
programme continues automatically.

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Press Start/Pause.
1.
Select the other programme.
2.
Press Start/Pause . The new
3.
programme starts from the
beginning.

Cancel the programme

Programmes at high temperatures:
Press Start/Pause.
1.
To cool the laundry: Select Rinse.
2.
Press Start/Pause .
3.
For programmes at low temperatures:
Press Start/Pause.
1.
Select Spin or Drain.
2.
Press Start/Pause.
3.
Programme end during rinse
hold
– – – 0 appears on the display panel
and the Start/Pause button indicator
lamp flashes.
To end the programme, set the
programme selector to Spin/Drain or
select a spin speed. Then press the
Start/Pause button.
20

Programme end

End appears on the display panel and the
Start/Pause button indicator lamp is off.
If the 9 symbol appears on the display
panel, the washing machine has detected
too much foam during the wash
programme and automatically switched on
a rinse cycle to remove the foam.
Add less detergent for the next
Note:
washing cycle with the same load.
Removing laundry/switching
off the appliance
Open the washing machine door
1.
and remove the laundry.
Set the programme selector to Off.
2.
The appliance is switched off.
Turn off the water tap.
3.
Not required for Aqua-Stop
Note:
models.
Notes
Do not leave any items of laundry in
■
the drum. They may shrink in the
next wash or discolour another item.
Remove any foreign objects from the
■
drum and the rubber seal – risk of
rusting.
Leave the washing machine door and
■
detergent drawer open so that any
residual water can dry away.
Always wait for the end of the
■
programme, otherwise the appliance
may still be locked. Then switch on the
appliance and wait for it to unlock.
If the display panel goes off at the
■
end of a programme, energy-saving
mode is active. To activate the panel,
press any button.