Sycamore Halo LED Tri-light SY7273 Quick Start Manual

Installation instructions : Halo LED Tri-light SY7273
Thank you for purchasing this SycamoreLED.com product. Please make sure instructions are followed carefully prior to and during installation
and product is not altered, otherwise warranty may not be valid. For technical support or warranty information please visit
www.sycamoreLED.com, or call our dedicated technical helpline +44 (0) 113 2866686.
1)
Please read these instructions carefully before commencing any work
2)
Please retain these instructions for future reference
3)
It is strongly recommended that this unit is installed by a qualified electrician in accordance with the IEE wiring
regulations and building regulations
4)
To prevent electrocution switch the power off at the mains supply before installing or maintaining this fitting
5)
Ensure others cannot restore the electrical supply without your knowledge
6)
The PSU must be rated 12VDC and be compatible with the pre-wired connector system of this product
7)
Never exceed the wattage stated
65 mm
Fix triangular body in position using screws provided
1)
Ensure that cable is located via cut out on spacer
2)
Connect into PSU using fast fit connector
3)
Insert light into spacer and check operation
4)
Please note this fitting has non replaceable parts
1)
Always switch off or disconnect from the mains when cleaning the product.
2)
We recommend cleaning with a soft dry cloth. Do not use scourers, abrasives or chemical cleaners.
3)
SycamoreLED.com
LS26 8XT
Technical helpline : 0113 2866686
*Please email sales@sycamoreled.com to register your product
IMPORTANT—Please read prior to installation
DIAGRAMS
14.7 mm
150.0 mm

INSTALLATION

126.0 mm
50.0 mm

CARE IN USE