Advertisement
Quick Links
Advertisement
Related Manuals for Atten AT-2233
Summary of Contents for Atten AT-2233
- Page 1 AT-2233 HEAT GUN USER MANUAL Please read this instruction manual before using your new power tools...
- Page 2 Your heat gun has been designed for stripping paint, soldering pipes, shrinking PVC, welding and bending plastic as well as general drying and thawing purposes.It is not designed for commercial use. WARNING! Read this manual and general safety Instructions carefully before using the appliance, for your own safety.
- Page 3 4.1 Work area 4.2 Electrical safety c shock. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. If operating a power tool on a damp location is unavoidable, use a residual current device (RCD) protected supply.
- Page 4 4.4 Power tool use and care Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate of which it was designed. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
- Page 5 Do not obstruct either the air intake or nozzle outlet, as this may cause excessive heat build up resulting in damage to the tool. Do not direct the hot air blast at other people. Do not touch the metal nozzle as it becomes very hot during use and remains hot for up to 30 minutes after use.
- Page 6 Bending plastic pipes and sheets. Soldering plumbing joints, tin, special silver solder, SMD elements, cable lugs. Loosening rusted or tightly fastened nuts and bolts. Removing old and even thick coatings of oil paint , lacquer, varnish and synthetic plaster. If you are not sure about the correct setting, start with a low temperature setting and gradually increase the temperature until you achieve optimum results.
- Page 7 8.INSTRUCTIONS FOR USE Always observe the safety instructions and applicable regulations. Use only one hand to hold the tool, do not place your other hand over the air vents. Prior to operation : Mount the correct accessory for the application. Set the desired air temperature.
-
Page 8: Maintenance And Cleaning
8.5 Cooling down The nozzle and accessory become very hot during use. Let them cool down before attempting to move or store the tool. To reduce the cooling time, set the on/off switch to position Ⅰ and let it run for a few minutes. Switch the tool off and let it cool down for at least 30 minutes. - Page 9 Waste produced by electrical machine items should not be handled like normal household rubbish. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. Fax:86-755-8602 1365 Tel:86-755-8602 1373 Web:www.atten.com Facebook:https://www.facebook.com/attencn/ MADE IN CHINA E-mail:sales@atten.com.cn...
Need help?
Do you have a question about the AT-2233 and is the answer not in the manual?
Questions and answers