EINHELL CE-BC 4 M Manual

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
This equipment can be used by children of 8 ye-
ars and older and by people with limited physical,
sensory or mental capacities or those with no ex-
perience and knowledge if they are supervised or
have received instruction in how to use the equip-
ment safely and understand the dangers which
result from such use. Children are not allowed
to play with the equipment. Unless supervised,
children are not allowed to clean the equipment
and carry out user-level maintenance work.
Waste disposal
Batteries: Only dispose of these items through
motor vehicle workshops, special collection
points or special waste collection points. Ask your
local council.
Explanation of the warning signs on the
equipment (see Fig. 4)
1 = The equipment is totally insulated
2 = CAUTION - Read the operating instructions to
reduce the risk of injury
3 = Fuse value on pcb
4 = Disconnect from the mains supply before
connecting or disconnecting the battery to or
from the charger.
IMPORTANT: Explosive gases. Avoid fl ames
and sparks. Provide good ventilation during
Anl_CE_BC_4_10_M_SPK9.indb 14 Anl_CE_BC_4_10_M_SPK9.indb 14
GB
the charging process.
2. Layout and items supplied
2.1 Layout (Fig. 1)
1 Function key
2 LCD display
3 Charging cable, black (-)
4 Charging cable, red (+)
5 Suspension eye
6 Mains power cable
2.2 Items supplied
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Original operating instructions
•
Safety instructions
3. Proper use
The charger is designed for charging non-
maintenance-free or maintenance-free 12V lead
acid batteries (wet / Ca/Ca / EFB batteries) and
for lead gel and AGM batteries which are used in
motor vehicles.
The 12V M charging program is suitable for
trickle charging and charging of batteries with
small battery capacities. The SUPPLY function
enables the device to be used as a buff er power
supply as well, e.g. while changing a battery or
for the operation of 12V d.c. consumers (observe
the max. power consumption). The RECOND
program is intended to be used only for bringing
lead acid batteries (not for AGM and GEL
batteries) which have undergone exhaustive
discharge back to life. Only use this program for a
- 14 -
28.03.2019 10:26:54 28.03.2019 10:26:54