DGSI TR-974 Manual

Hose Barb Sizes
Exhaust Hose Barb Air Inlet Push-To-Connect
3/8 in I.D. Buna-N ¼ in O.D. Tubing.
Warning: All tubing or hoses attached to the pump must be secured with
an appropriately sized hose clamp.
Additional Info.
When calling for
parts or service,
please include the
serial number of
your pump.
Additional drawings and parts lists can be found at www.DGSI.info
Durham Geo Slope Indicator
2175 West Park Court
Stone Mountain, GA 30087
USA
Fluid Discharge Hose Barb
¾ in I.D. Buna-N Hose
The quick-link
chain loop is
for securing
the pump to
the restraining
cable.
+1.770.465.7557
Fax: 770.465.7447
e-mail: solutions@durhamgeo.com
www.DurhamGeo.com
SRX-R PUMPS
Models TR-974 & TR-976
Quick Start Guide V1.1
Unpacking and Preparation
To remove the pump, separate the packing tape
and four staples from the sides of the box, then
pull apart the two box halves.
IMPORTANT! You will need to first remove
the internal packaging before the pump can
be used. A tag will be attached to the pump
alerting you of this.
1. Remove the two bolts from the
bottom assembly using either a ½ in
socket or adjustable wrench.
2. Remove the bottom assembly.