Encore ENVCWI-G2 Advanced Installation Manual page 40

Event Configuration >> Motion Detect Trigger
Select the Enable option to enable the trigger function of the camera,
so that you can send captured images within the detecting area to
the FTP server, email receiver, Network Storage server, or the
connected USB device. You have to configure corresponding
settings, such as FTP server and email server, to enable this feature.
- Schedule Profile: Select a schedule profile from the pull-down
list.
- Action: Select the destination that the captured images will be
sent to: Send Email, FTP Upload, Record to Network
Storage, or Save Image to USB.
Event Configuration >> Schedule Trigger
You can separately configure the schedule for trigger function of the
camera by Email, FTP, or Network Storage. Select the Enable
option on each item, and then select a Schedule Profile from the
pull-down list and set the Interval time.
NOTE If the setting value of the Network Storage Recording Time
Per Event option in General Setting is longer than the
Interval time in Network Storage Schedule, the recorded file
will be a continuous video clip.
For example, if you set the Network Storage Recording
Time Per Event as 10 seconds and the Interval as 5 seconds,
recorded file becomes a non-stop video clip because the
camera will record a 10-second video clip every 5 seconds.
- 39 -