Battery Maintenance - prime3 EES21 Owner's Manual

EES21
• Do not climb on the scooter before turning on the power or if the scooter is in a bad technical condition. This
can cause imbalances and injuries.
• Do not board a scooter until the diagnostic process is complete after it has been started. Stop if you
hear disturbing noises or feel vibrations from your scooter even if the display is working properly.
Cleaning and storage
• Clean the scooter after each ride.
• If the rubber surfaces are difficult to clean, use a toothbrush and toothpaste and clean them with a soft
cloth. This method can also remove small scratches.
• Store the scooter indoors, in a cool and dry place. Do not expose the scooter to prolonged sunlight. When
cleaning, the battery charging receptacle must be tightly closed, otherwise you may be electrocuted and the
scooter may be seriously damaged. Do not wash your scooter under a high pressure water jet or immerse it
in water - this may cause irreparable damage to the unit.

Battery maintenance

The battery is the most important part to maintain. To extend its service life, follow the instructions below:
• Read and follow the notes on battery marking.
• The best battery storage temperature is 0 degrees. Do not store the battery pack at temperatures below -20
degrees or above 50 degrees.
• Store the battery in a cool and dry place. A very humid place can cause condensation inside the battery,
which can quickly damage the battery.
• When the display shows a low level of battery, connect the battery pack to the charger. Try to prevent the
battery from draining completely. Please charge the battery fully before starting to drive. Frequent charging
will not damage the battery. On the contrary, long-term storage of an uncharged battery can shorten its
service life.
Features and Specifications:
• Motor Size: 250 W
• Battery: 36 V, 6 Ah
• Max speed: 20 km/h
• Running distance: ~15 km (depending on rider weight and type of pavement)
• Max. weight: 100 kg
• Upslope: 15 - 20 degrees
• Front brake, rear fender brake (foot brake)
• 6.5-inch wheels
• Front LED lamp
• LCD for indicating speed and battery-charge level
• Easy folding mechanism
• Power supply: 100 - 240 V ~ 50/60Hz, 1.5 A
• Charging time: ~ 3 hours
• Dimensions: 1050 x 143 x 295 / 1026 x 950 x 528 mm (folded / assembled)
• Net weight: 9.4 kg
Technical data of adaptor:
• Input voltage: 100 - 240 V ~ 50/60 Hz
• Max. Input current: 1.5 A
• Output voltage: 29.4 V
• Max output current: 15 A
8