FCC Part 15 B Notice
CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions :
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
This product is manufactured by Amax Group
12645 Memorial Drive, Suite F1, #388, Houston, TX 77024
Smart Bots™ are the registered trademarks of Amax Group
© 2021 All rights reserved. Visit us at www.amaxbrands.com
KEEP THIS PACKAGE FOR REFERENCE AS IT CONTAINS IMPORTANT INFORMATION.
Conforms to safety requirements of ASTM, CPSIA, and FCC.
NOTE:
THIS SNAKE IS BUILT FOR INDOOR USE ONLY AND WILL ONLY WORK ON
SMOOTH AND FLAT SURFACES. PLAYING WITH THIS PRODUCT OUTDOORS
OR ON A CARPET MAY PERMANENTLY DAMAGE THIS PRODUCT.
FOR BEST RESULTS, ALWAYS POINT THE TRANSMITTER DIRECTLY
TOWARDS THE HEAD OF THE SNAKE FROM WITHIN A FIVE FOOT RADIUS.
INFRARED BEAMS DO NOT BOUNCE OF BLACK/DARK MATTE SURFACES
AND MAY AFFECT TRANSMISSIONS FROM CONTROLLER.
Distributed by:
TRACTOR SUPPLY COMPANY
5401 VIRGINIA WAY
BRENTWOOD, TN 37027
For customer support,
call: 1-888-376-9601
www.TractorSupply.com
9
Warning: roboratler snake is an infrared snake. Due to the interference of the sun, the
infrared signal can not work in the daytime. Refer to the attached safety instructions.
PACKAGE CONTAINS:
R/C Snake
Made in China
C012-USA-V1.0
ARTWORK NO.
C12
INSTRUCTION MANUAL
Wireless Infrared
Controller
Product may vary slightly from photograph.
DESCRIPTION
MDSER
112×172mm
Instruction Booklet
DESIGNER
DATE
Johnny
2020/4/08
Need help?
Do you have a question about the SMART BOTS and is the answer not in the manual?
Questions and answers