Page 1
RANGE HOOD / HOTTE DE VENTILATION MODELS / MODÈLES: CVW502, CVW502B INSTALLATION GUIDE / USE AND CARE MANUAL INSTRUCTIONS D’INSTALLATION / GUIDE DE L’USAGER Installer: Leave this manual with the homeowner. Homeowner: Keep this guide for future reference Installateur : Laissez ce manuel au propriétaire.
Introduction Thank you for choosing this extractor hood. To ensure that you get the best results from your new extractor, we strongly suggest that you read this instruction manual thoroughly before use. If treated with care, your extractor should give you years of trouble- free use To register ownership, please ensure you complete and return the guarantee card supplied with the appliance.
Page 4
Safety precautions, Continued - If the room where the hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the sealed or balanced flue type. If other types of flue or appliances are fitted ensure that there is an adequate supply of air to the room.
Installation Prepare for the installation: a. If you have an outlet to the outside, your cooker hood can be connected below picture by means of an extraction duct with an as per the interior diameter of 150mm. Before installation, turn the unit off and unplug it from the outlet. c.
Page 6
Installation – ducted Attention! Observe the warning concerning the operation of the appliance when air is discharged from the room. Drill 3 x 8mm holes to accommodate the bracket. Screw and tighten the bracket onto the wall with the screws and screw plugs provided. Screw (4mm x 30mm) Holes on wall...
Page 7
Fix the one-way-valve to the air outlet of the cooker hood. Then, attach the exhaust pipe to the one-way-valve as shown below. Exhaust pipe Cooker hood Chimney installation. Place the upper chimney into the lower chimney. Use 2 pcs ST4x8mm screws to attach lower and upper chimney together. Before attaching the bracket to the chimney, decide the location of lower chimney bracket fixing holes for fixing the lower chimney bracket in the later steps.
Page 8
Drill 2 holes to accommodate the plate II. Screw and tighten the plate II onto the wall with two screws and wall. plugs provided Slide up the upper chimney and fix the upper chimney with plate II with 2 screws ST4x8mm Fix the lower chimney with the hood with 2 screws ST4x8mm...
Installation – recirculation mode If you do not have an outlet to the outside, the exhaust pipe is not required (as shown in the section “Installation - ducted”). Installing the charcoal filter An activated charcoal filter can be used to trap odours. In order to install the charcoal filter, the grease filter should be detached first.
Operation Touch control On/Off button It is used for turning on/off the fan. Speed plus button For increasing the speed of the fan Speed decrease button For decreasing the speed of the fan. Light button Digital display Fan speed display:"1" for Low speed, "2" for Medium speed, "3"...
Care and maintenance IMPORTANT: Before cleaning or maintenance please switch off the electricity supply and remove the plug from the wall. Regular cleaning Use a soft cloth moistened with lukewarm mildly soapy water or household cleaning detergent. Never use metal pads, chemicals, abrasive material, abrasive cleaning creams or stiff brushes to clean the appliance.
Page 12
Replacing the bulb: Model CVW502 1.Switch the unit off and unplug the appliance. 2.Remove the lamp cover by unscrewing the 2 screws. 3.Unscrew the bulbs. 4.Replace with the same type and rated bulb/lamp. Replacing the bulb: Model CVW502B-Panel Light REPLACING THE LED LIGHTING PANEL 1.
Troubleshooting Fault Cause Solution The fan blade is jammed. Switch off the unit and The lights on, but the fan does repaired by qualified not work The motor is damaged. service personnel only. A blown fuse Replace the fuse The lights and fan do not work The power cord is loose.
Environmental protection Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. This appliance is marked according to the European directive 2012/19/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this...
This warranty covers parts and labour from a Caloric™ authorized company, up to a maximum of one (1) hour. Proof of payment to the service company is required.
Page 16
We do the utmost to ensure that the provided information is complete and accurate, however, images and specifications are subject to change without notice. www.caloricappliances.ca Visit our website at for the latest English or French version of this manual. In Canada CALORIC™ is a registered trademark of J.A.K. North America Inc.
Need help?
Do you have a question about the CVW502 and is the answer not in the manual?
Questions and answers