Lafayette Auto-Wand V2 Programming Instructions

Advertisement

Auto-Wand V2

Overview

Auto-Wand V2 offers a wirefree, rechargeable, easy to program and
use solution to suit a large range of applications.
The favorite position feature allows a pre-set position to be recalled
for precise alignment at a desired mid window position.
Auto-Wand Programming Instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Auto-Wand V2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Lafayette Auto-Wand V2

  • Page 1 Auto-Wand Programming Instructions Auto-Wand V2 Overview Auto-Wand V2 offers a wirefree, rechargeable, easy to program and use solution to suit a large range of applications. The favorite position feature allows a pre-set position to be recalled for precise alignment at a desired mid window position.
  • Page 2 Button Description Prior to programming. Your shade should be pre-programmed. If you need to adjust a limit please go to that section. If you have fully reset your motor then you will need to start at programming check motor direction. Programming Check motor direction To check travel direction of shade, press UP...
  • Page 3 Setting Limits Move shade to desired highest or lowest Once you are at your upper limit, hold UP and position by pressing the UP or DOWN STOP. buttons Once you are at your lower limit, hold DOWN and STOP. DONE! Adjusting Upper Limit You can do this at ANY position.
  • Page 4 Favorite Position Hold the STOP button on Hold the STOP button on Move shade to the desired favorite position the wand and the shade the switch again and the will jog once then release shade will jog twice. To send the shade to your favorite position press and hold the STOP button until the shade starts to travel.

Table of Contents