Advertisement
Customer Service 800-383-0269
HOW TO TAKE CARE OF YOUR ALARM
This CO Alarm is designed to be as maintenance free as possible.
To keep your alarm in good working order, you must:
TEST THE ALARM WEEKLY.
Procedure, in this manual for further information.
VACUUM THE DUST OFF THE ALARM COVER. At
least once a month (more frequently in dusty locations), use the
soft brush attachment of your vacuum to clean the alarm cover.
CLEAN THE ALARM COVER WHEN DIRTY. Wash the
alarm cover by hand. Use a cloth dampened in clean water. Dry
with a soft cloth.
DO NOT SPRAY CLEANING AGENTS OR WAXES
DIRECTLY ONTO THE FRONT PANEL. This action may
damage the sensor, cause an alarm or cause an alarm
malfunction.
OBSERVE THE COLOR OF THE INDICATOR LIGHT.
At frequent intervals and during your weekly test, check the
indicator light on the on the front panel of the alarm.
See the section, Operation, in this manual for further
information.
PROCEDURES TO TAKE DURING AN CO ALARM
Follow the alarm procedures for your country. The emergency number
depends on your travel location.
PROCEDURES TO TAKE
DURING A CO ALARM IN THE USA
!
WARNING
: Actuation of this device indicates the
presence of carbon monoxide (CO) gas, which can KILL
YOU. If signal sounds (4 beeps and flashing or solid red
light): 1) Operate the Test/Mute button; 2) Call your
emergency local service (Phone Number _____________ )
(fire department or 911); 3) Immediately move to fresh air
- outdoors or by an open door/window. Check that all
persons are accounted for. Do not reenter the premises or
move away from the open door / window until the
emergency responders have arrived, the premises have
been aired out and your alarm remains in its normal
operation. 4) After following steps 1-3, if your alarm
reactivates within a 24-hour period, repeat steps 1-3 and
call a qualified appliance technician. (Phone Number
_______________) to investigate for sources of CO from
fuel burning equipment and appliances, and inspect for
proper operation of this equipment. If problems are
identified during this inspection have the equipment
serviced immediately. Note any combustion equipment not
inspected by the technician and consult the manufacturers'
instructions, or contact the manufacturer directly, for more
information about CO safety and this equipment. Make
sure that the motor vehicles are not, and have not been,
operating in an attached garage or adjacent to the
residence.
www.safetalert.com
See the section, Test
PROCEDURES TO TAKE
DURING A CO ALARM IN CANADA
!
WARNING: Actuation of this device indicates the
presence of carbon monoxide (CO) gases which can KILL
YOU. If signal sounds (4 beeps and flashing or solid red
light: 1) Operate the Test/Mute. Immediately move to fresh
air - outdoors or by an open door/window. Check that all
persons are accounted for. Do not reenter the premises or
move away from the open door/window until the emergency
responders have arrived, the premises have been aired out,
and your alarm remains in its normal condition; 2) call your
emergency local service (telephone number _________) (
Fire department or 911).
DO NOT REPLACE BATTERY
End of Life Signal – The Sensor has a 5 Year Service Life
All SA-340 models include an End of Life (EOL) Signal indicating
the sensor has reached the end of its 5 year service life and you must
replace the alarm. The signal is the LED flashing RED RED
GREEN GREEN with a beep every 25-30 seconds. The EOL Signal
may be reset by pushing TEST / RESET button on the alarm. This
will reset the EOL Signal for a period of 72 hours (3 days) for a total
of up to 30 days. After 30 days the signal cannot be reset and the
alarm must be replaced. DO NOT REMOVE THE ALARM UNTIL
YOU HAVE A REPLACEMENT ALARM AVAILABLE TO
INSTALL.
END OF LIFE (EOL) DIRECTIONS
1.
Unscrew the screws with a Phillips screwdriver. Placement
marked by this image:
2.
Remove back panel.
3.
Remove battery. Discard or recycle battery and circuit
board. Replace with new alarm.
Important: Removing /damaging label or opening the alarm voids
warranty. Only open at EOL.
SPECIFICATIONS
MODEL
POWER SUPPLY
OPERATIONAL TEMPERATURE
RELATIVE HUMIDITY
AUDIBLE OUTPUT
CO ALARM TRIGGER
CASE MATERIAL
CASE DIMENSIONS
WARRANTY
Conforms To ANSI / UL STD 2034
SA-340
Sealed In 3V Long life Lithium battery
o
o
o
o
-40
F to +150
F
-40
C to +66
C
15% (+/- 5%) to 95% (+/- 4%)
85 dB @ 10 feet
<15 Minutes @ 400 ppm
ABS
4.75" x 2.75"
1 Year Limited
Advertisement
