Open The Uefi/Bios Setup Utility; Change The Startup Sequence; Change Hotkey Mode; Enable Or Disable Always-On - Lenovo Yoga 7 User Manual

Open the UEFI/BIOS setup utility

Step 1. Turn on or restart the computer.
Step 2. Press F2 repeatedly.
Note: For computers with hotkey mode enabled, press Fn + F2.

Change the startup sequence

You may need to change the startup sequence to allow the computer to start from another device or a
network location.
Step 1. Open the UEFI/BIOS setup utility.
Step 2. Navigate to the Boot menu.
Step 3. Follow on-screen instructions to change the order of devices under Boot Priority Order.
Note: You can also change startup sequence temporarily without opening the setup utility. To do so, start
the computer. When the Lenovo logo appears, press F12 (or Fn + F12) repeatedly.

Change hotkey mode

Step 1. Open the UEFI/BIOS setup utility.
Select Configuration ➙ Hotkey Mode and press Enter.
Step 2.
Step 3. Change the setting to Disabled or Enabled.
Select Exit ➙ Exit Saving Changes.
Step 4.

Enable or disable always-on

For some Lenovo computers with always-on connectors, the always-on function can be enabled or disabled
in the UEFI/BIOS setup utility.
Step 1. Open the UEFI/BIOS setup utility.
Step 2. Select Configuration ➙ Always On USB and press Enter.
Step 3. Change the setting to Disabled or Enabled.
Step 4. Select Exit ➙ Exit Saving Changes.

Set passwords in UEFI/BIOS setup utility

This section introduces the types of passwords that you can set in the UEFI (Unified Extensible Firmware
Interface) or BIOS (Basic Input/Output System) setup utility.

Password types

You can set various types of passwords in the UEFI/BIOS setup utility.
Password type
Administrator password
User password
Pre-requisite
No
The administrator password must be
set.
Usage
You must enter it to start the setup
utility.
You can use the user password to
start the setup utility.
.
Chapter 3 Explore your computer
23