Advertisement
4. CONTENTS/ASSEMBLY
Contents:
•
Lift Table
•
Lifting Pedal
•
Handle assembly
•
Wheels
•
Bolts, Washers, R-pins
WARNING! A minimum of two people will be required to lift the truck out of its packaging.
4.1. Fitting the handle.
The truck is almost completely assembled when you unpack it. To complete assembly refer to the diagram on page 3.
4.2. Fit the lifting pedal (27) into the lifting pedal assembly (30) using bolt (29).
4.3. Fit the handle(21) to the base assembly (17) using bolt (20).
5. USING THE TRUCK
5.1. Before first use.
5.1.1. Before using the truck for the first time purge any air from the hydraulic circuit by pumping the foot pedal (27) 10 to 15 times
whilst holding the release lever (22) in.
5.1.2. To test the truck, release the lever which will close the hydraulic valve. Pump the foot pedal (27) and raise the truck platform to
its highest position and then pull the release lever (22) to lower the platform, (the platform may be slow to descend
immediately from its highest point).
5.2. Using the truck.
WARNING! Ensure you read, understand and follow the safety instructions. Ensure all Health and Safety, local authority, and
general workshop practice regulations and recommendations are strictly adhered to when lifting or moving heavy loads.
The lifting or movement of heavy loads may be dangerous if not undertaken correctly.
WARNING!
The warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this
product, but must be applied by the operator.
5.2.1. Move the truck to the required loading area and lock the truck wheels by operating the foot pedal brake.
5.2.2. Raise the platform by pumping the foot pedal (27) to the loading height and engage safety bars (7).
5.2.3. Load the truck ensuring that the load is evenly distributed on the platform.
5.2.4. Remove safety bars (7) and use release lever (22) to lower the truck platform to the lowest position before unlocking the
wheels and transporting the load to the required destination.
WARNING! Ensure the load will not foul on anything, and is clear of your hands and the handle when lowering.
5.2.5. To unload, lock the wheels and if required raise platform and engage the safety bars, then unload the truck.
Note: With or without a load, always transport the truck with platform in its lowest position. When not in use, store the truck with
the platform in the lowest position.
6. MAINTENANCE
6.1. When the truck is not in use, the platform must be in the lowest position to minimise ram and piston corrosion.
6.2. Keep the truck clean and wipe off any oil or grease. Lubricate all moving parts with acid free oil.
DO NOT use truck if believed to have been subjected to abnormal load or shock load. Inspect and if necessary take
appropriate action.
6.3. Periodically check the pump piston and piston rod for signs of corrosion. Clean exposed areas with a clean oiled cloth.
IMpORTANT: Only fully qualified personnel should attempt maintenance or repair of the truck hydraulic system.
The oil cylinder is a sealed unit and must not be accessed. For service contact your authorised dealer.
WARNING! Only a good quality hydraulic oil, such as SEALEY HYDRAULIC JACK OIL must be used, DO NOT use
brake fluid.
IMpORTANT: NO RESpONSIBILITY IS ACCEpTED FOR INCORRECT USE OF THE TRUCK.
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the UK.
DO NOT RETURN TRUCK TO US. Please telephone 01284 757500 to obtain address and 'phone number of your local agent.
If truck is under guarantee please contact your dealer.
De-commissioning the truck: Should the truck become completely unserviceable and require disposal, draw off the oil into an
approved container and dispose of the truck and the oil according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMpORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
www.sealey.co.uk
01284 757500
Web
sales@sealey.co.uk
01284 703534
email
HPT750.V2
Issue: 2 - 15/10/09
Advertisement
