DuroStar DS11000DX User Manual page 37

5.
Close choke
The choke lever is located above the air filter to the left of
the recoil start. Slide the lever to the left to cut the air supply
and allow more gas into the engine to start.
6.
Pull the recoil start
The recoil start is located on the left side panel next to the air
filter. Pull the recoil handle slowly until resistance is felt, then
quickly pull the recoil handle until fully extended.
CAUTION:
has retracted. Releasing the recoil handle while extended
may cause harm to yourself or your equipment.
7.
Open choke
Push the choke to the OPEN position as the engine warms up.
8.
Turn breaker ON and connect
The breaker is located on the right side of the front power
panel. Flip the breaker up to allow the power to flow to the
receptacles. Connect your devices to the receptacles on the
front panel. Start with the largest loads first.
Release the recoil handle only after the cord