Electrolux EWF9024BDWA User Manual page 32

32 www.electrolux.com
Malfunction
Machine
vibrates or
is noisy:
Cycle time
longer than
displayed:
The cycle is
shorter than
the time
displayed.
Spinning
starts late
or machine
does not
spin:
Machine
makes an
unusual
noise:
No water is
visible in
the drum:
Possible cause
The laundry is not evenly
distributed in the drum.
There is very little laundry in the
drum.
Unstable floors eg. wooden floors.
Detergent over dose.
Machine unbalance.
The appliance calculated a new time according to the laundry
load.
The electronic unbalance detection
device has cut in because the
laundry is not evenly distributed in
the drum. The laundry is
redistributed by reverse rotation of
the drum.
This may happen several times
before the unbalance disappears
and normal spinning can resume. If,
after 10 minutes, the laundry is still
not evenly distributed in the drum,
the machine will not spin. In this
case, redistribute the load manually
and select the spin program.
Machine not installed properly.
Transit bolts or packaging not
removed.
The load may be too small.
Machines based on modern technology operate very economical-
ly using very little water without affecting performance.
Solution
Pause the machine and
redistribute laundry
manually.
Load more laundry.
Refer to relevant paragraph
in "Positioning" section.
Reduce the detergent
quantity or use another one.
(Refer page 23 "Detergents
Type And Quantity Of
Detergent").
Redistribute laundry
manually in the drum and
start the spin phase again.
Pause the machine and
redistribute laundry
manually.
Make sure the levelling of
the appliance is correct.
Refer to "Installation".
Make sure that the
packaging and/or the
transit bolts are removed.
Refer to "Unpacking".
Add more laundry in the
drum.