Emprex D350PE Quick Start Manual

Quick Start Guide

1

GENERAL INFORMATION

This Secure Drive Enclosure kit package contains:
• HDD Enclosure
• USB cable
• Software, Driver and Manual CD
• Quick Start Guide
• Power Adapter
Screws / Screwdriver (for applicable models only)
•
2

GETTING STARTED

Hardware Installation

Assembling your hard drive to the Enclosure kit
1. Open the case with a screwdriver.
2. Gently lower the hard drive to rest
1. Pull out the tray of the
HDD case.
against the board.
3. Fasten the hard drive's
mounting holes to the Case
Frame with 2bigger screws.
5. Push the hard disk into
the case.
Note: The pictures are only for illustration and actual accessories may
differ from picture.
•
Mac users please refer to Mac user guide in utility CD.
3

SETTING UP

Security Software Setup
1. Insert the Installation CD into your CD-ROM drive.
Select "Software & Win98 driver".
Version 1.0 Sep. 2007
2. Connect the tray to your
hard disk
4. Plug the LED power
connecter.
6. Fasten the hard disk to the
case
7. Connect the USB/Power
cable to correct port.
8. Turn on the power switch.
2. When this screen appears,
For Windows 98/SE:
Select "Install Win98 Driver" before proceeding to next
step.
For Windows XP/Me/2000/Vista
Select "Configure to Secure Drive".
Caution:
Configuring to Secure Drive destroys any existing data. Be sure to
back up the disk contents first.
3. When this screen appears, follow the on-screen instructions.
1) Enter【New Password】
2) Re-enter【Confirm New Password】
3) At【Hint】prompt, enter a suitable phrase to help you recall
your password later on.
4) Click【Prepare Secure Drive】
When the installation is complete, please re-connect the USB
4.
drive into the computer's USB port for the new configuration to
take effect.
Note: In order to remove the device to take effect, you could choose either
device' end or computer's end (USB cable) to unplug and re-plug
the USB cable. Otherwise, system will still show the old data in the
drive.