Emerson HK95 Important Safety Instructions Manual page 5

HK95.OM.QXD 8/20/02
ASSEMBLY AND OPERATION INSTRUCTIONS
Follow these instructions to assemble the Glitter Lamp:
1
B
C
Carefully unpack the Glitter Lamp
from the box. Position body (B) on
base (C) and make sure it is secure.
NOTE: Check to make sure that the
bulb is tight. Gently tighten if
necessary.
3
Plug in the Glitter Lamp as
described in the section above and
turn the ON/OFF switch On.
Remember, initial warm-up will take
about 30 minutes.
If the glass cylinder has broken, the exposed liquid is not harmful if handled
properly as follows:
1. Wear rubber gloves when cleaning up to protect against skin irritation and
to prevent cuts from broken glass.
2. Carefully pick up and dispose of broken glass.
3. Use disposable towels to soak up excess liquid. Do NOT use water or
other cleansers to aid in clean up as the liquid is not water-soluble.
4. After the liquid has been cleaned up, cleanser can be used. Clean
thoroughly to remove any stains and odors.
11:27 AM Page 5
Position cap (A) on body (B) and
make sure it is secure.
NOTE:
Please read all of the safety
instructions on page 2 before
assembling.
CLEAN UP INSTRUCTIONS
5
2
A
B