Table of Contents
Advertisement
HK95.OM.QXD
8/20/02
IMPORTANT SAFETY INSTRUCTIONS (CONTINUED)
THE GLITTER LAMP IS NOT A TOY. IT SHOULD BE KEPT OUT OF THE
REACH OF CHILDREN. THE GLASS CYLINDER GETS HOT WHILE THE LAMP
IS OPERATING AND REMAINS HOT FOR SEVERAL HOURS AFTER THE
LAMP IS SWITCHED OFF. THE GLASS CYLINDER WILL BREAK IF THE LAMP
IS KNOCKED OVER, DROPPED OR STRUCK WITH A HARD OBJECT.
IF THIS GLITTER LAMP IS INTENDED TO BE USED IN A CHILD'S ROOM, IT
MUST BE POSITIONED IN SUCH A WAY THAT NEITHER THE LAMP ITSELF
NOR THE AC POWER CORD IS ACCESSIBLE TO THE CHILD.
DO'S & DON'TS:
Please follow the precautions below:
DO'S
•
DO have the glitter lamp at room temperature before starting.
•
DO allow the glitter lamp to warm up for about 30 minutes to insure it performs
at its optimal level.
•
DO operate glitter lamp on flat and stationary surfaces which are at room
temperature.
•
DO keep glitter lamp and cord out of reach of small children's and pets.
•
DO handle the glass glass cylinder with extreme care. The glass cylinder may
break if dropped, knocked over or subject to any form of sudden impact. If it
becomes necessary to clean up broken glass, then use care and sufficient
safety precautions (Refer to Clean Up Instructions.)
•
DO check to see if the light bulb and socket in the base are completely
centered and tightened. The light bulb and socket may have moved during
shipping. If this has occurred, then gently use your fingers to re-center it.
Before touching the lamp, make sure it is cool and unplugged.
•
DO exercise caution when handling the glitter lamp when it is plugged in. It
takes two to three hours for the glitter lamp to cool once it is turned off.
DON'TS
•
DO NOT place the glitter lamp near sources of heat or cold, such as a heater or air
conditioner. The lamp operates best at room temperatures between 70°F to 79°F.
•
DO NOT move or shake the glitter lamp while it is HOT; doing so may cause it
to permanently malfunction.
•
DO NOT operate or store the glitter lamp in direct sunlight; doing so may cause
the colors to fade.
•
DO NOT try to force the polarized plug into an outlet. As a safety precaution,
one blade on the plug is wider than the other and can only be inserted one way
into an outlet.
•
DO NOT operate the glitter lamp for more than six hours at a time.
•
DO NOT remove the CAP on the glass cylinder or add any fluids or solids to
the lamp: Breaking the seal on the glass cylinder will void the warranty.
•
DO NOT operate the lamp on Glass Surfaces.
•
DO NOT break the seal on the cap to fill with liquid or solids. Breaking the seal
will void the warranty.
11:27 AM
Page 2
2
Advertisement
Table of Contents
