Beghelli OTTICA RUNNING MAN Instructions

When using electrical equipment, basic safety precautions should always be followed including the following:
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS
2. Disconnect power before performing work on electrical equipment.
3. Do not use outdoors.
4. Do not let power cords touch hot surfaces and do not mount near gas or electric heaters.
5. Use caution when servicing batteries. Battery acid can cause burns to skin and eyes. If acid is spilled on skin or eyes, flush with fresh
water and contact a physician immediately.
6. Equipment should be mounted in locations and at heights where unauthorized personnel will not readily subject it to tampering.
7. The use of accessory equipment not recommended by BeLuce Canada Inc. as it may cause an unsafe condition, and will void the unit's
warranty.
8. Do not use this equipment for other than its intended purpose.
9. Servicing of this equipment should be performed by qualified service personnel.
10. SAVE THESE INSTRUCTIONS!
1. Extend 24 hour AC supply sign of rated voltage (see product label) to an electrical box installed in the location and
orientation where the canopy can be mounted to it. Leave at least eight (8) inches of slack wire. The circuit
should not be energized at this time - do not energize the AC supply until indicated.
2. Remove plastic bag surrounding sign and put on the plastic gloves located inside the bag before handling the sign
directly (to protect against smudges and smears).

TO CHANGE RUNNING MAN PICTOGRAM (IF NECESSARY)

a. Unscrew one end cap (Figure 2).
b. Slide faceplate assembly out of cylinder (Figure 2).
c. Remove buttons (Figure 11).
d. Exchange pictogram.
e. Reinstall buttons press together (Figure 12).
f. Slide face into cylinder & screw on end cap.

WALL/CEILING MOUNTING

3. Internal wiring is already pulled into the canopy and all wires are labelled. Connect AC supply per diagram
provided (Figure 3). Remove mounting plate from canopy and secure mount plate to junction box. Insulate unused
wire! CAUTION! - Failure to insulate unused wire may result in a shock hazard or unsafe condition as well as
equipment failure.
4. For self-powered sign, connect battery.
5. To change mounting type from ceiling mount to wall mount rotate canopy 90° (Figures 8, 9, 10).
6. Secure the sign to the mounting plate with two screws through the mounting holes in the canopy
(Figures 4 & 5 ceiling/wall mounting) (Figures 6 & 7 end mounting).
7. Energize power to fixture.

END MOUNTING

8. Internal wiring is already pulled into the canopy and all wires are labelled. Connect AC supply per diagram
provided (Figure 3). Remove mounting plate from canopy and secure mount plate to junction box. Insulate unused
wire! CAUTION! - Failure to insulate unused wire may result in a shock hazard or unsafe condition as well as
equipment failure.
9. Install spider plate to J box.
10. Secure exit to spider plate with two screws through mount holes in canopy.
11. Energize power to fixture.
BeLuce Canada Inc., 3900 14th Avenue, Markham, ON L3R 4R3 P: (905) 948-9500 F: (905) 948-8673
926000226
OTTICA RUNNING MAN (OT-RM)
INSTRUCTIONS

IMPORTANT SAFEGUARDS

INSTALLATION