Talk To Me Technologies wego A Quick Reference

Setup Instructions

Turn on the TTMT Switch Interface, using the on/off switch
located on the side of the interface box. You will see a red
power light to indicate the interface is turned on.
Ensure the Switch Interface is connected to the wego via
Bluetooth.
1. Exit the communication software. If you are unable to exit
the software, you may be in Guided Access.
2. Open the iOS Settings
Bluetooth is toggled On. Under My Devices, you should
see TTMT Switch listed as Connected. If not, tap on
"TTMT Switch" to connect. You may see a pop-up
Bluetooth Pairing Request, if so, press Pair.
3. Once the Switch Interface is connected via Bluetooth, you
can plug in your switches and begin setup. Connect your
Switch or Switches to the TTMT Switch Interface.
The Switch Interface can be used with one or two switches.
For single-switch scanning, plug your switch to Switch Port 1.
For two-step scanning, plug in both switches, with your
"chooser" in Port 1 and your "mover" switch in Port 2.
Need help?
wego A
TM
TTMT Switch Interface - GoTalk NOW PLUS
then select Bluetooth. Ensure
877.392.2299 Option 3
Quick Reference
Setup with GoTalk NOW PLUS
1. Return to the communication app, GoTalk NOW PLUS.
Open Settings and Scroll to Scanning.
2. Select Scanning Device Type > Space and Enter Switch.
3. Determine Scanning Mode.
a. For single-switch scanning, toggle on Auto Scan.
b. For two-switch scanning, toggle off Auto Scan.
4. Select Grouping Style (row, column, etc), Speed, Repeat,
etc. as preferred.
5. Press Done to close Settings and return to Player Mode.
Note: If these instructions do not match your current vocabulary set, please contact
Technical Support for assistance.
support@talktometechnologies.com
talktometechnologies.com
WCD-0920