Flashlight Operation - Matco Tools MUC122LED Manual

WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.

FLASHLIGHT OPERATION

Installing Or Removing Battery Pack
(See Fig .1, Fig .2)
1 . Your new battery pack is not
fully charged . You may need to
charge it before use .
2 . Make sure the switch is in the
"off" position before insertion/
removal of a battery pack .
3 . To remove a battery pack,
depress both tabs on either
side of the battery and pull
downward .
4 . To insert a battery pack, align
the battery with the light
housing and push battery
inward until click indicating
battery is fully installed .
Charging The Battery Pack
(See Fig .3)
1 . Battery may not charge when
it is above a certain preset
temperature limit . Allow temperature of battery to cool before
charging .
2 . The charge process will take less than one hour .
3 . After charging, unplug the charger from the power source and
stow away in a safe place .
MUC122LED
MUC122LED 12V LITHIUM-ION LED FLASHLIGHT
Fig. 1
Fig. 2
Fig. 3
Light Operation
The cordless light is intended to illuminate a limited work area .
For replacement of LED, return to an authorized Matco
Service Center .
3 rev. 12/27/12