Atc Command - Ebyte E70-433NW14S User Manual

Chengdu Ebyte Electronic Technology Co,;Ltd

9. ATC Command

When the serial port enters AT mode, it needs to open the serial port assistant, set the serial port (default parameter) baud
rate 115200, data bit 8 bit, stop bit 1 bit, open the serial port, input "+++" without carriage return. All parameter set tings
will reply "\r\n+OK\r\n".
Enters" +++" into AT Command
1
Example：+++
Note: 1. The AT command can be used only after entering the AT command mode
2. After entering the AT command mode, the AT command mode can be used again only after exiting the AT command
mode, reset or restart the module
3. When writing this instruction, the serial debugging assistant must be set not to send new lines; writing other AT
commands must be set to send new lines.
AT+EXIT Exit AT command mode
2
Example：AT+EXIT
Note: AT commands are invalid after exiting AT command mode
AT+HELP Help command
3
Example：AT+HELP
AT+ WMCFG
AT+ WM CFG =?
4
AT+ WM CFG =Value
Chengdu Ebyte Electronic Technology Co,;Ltd
Copyright ©2012–2019，
+++
AT+EXIT
AT+HELP
Setting /Querying working mode (reboot valid)
Parameter Description:
Nonparametric
Response:
Enter AT M ode
Parameter Description:
Null
Response:
Exit AT M ode
Parameter Description:
Null
Response:
All instructions and help information
Description:
Gets working mode
Response：
WM CFG：4
Description:
Value：0~4
0，Coordinator；
1, Normal node;
E70-433NW14S user manual
15