Advertisement
INSTALLATION INSTRUCTIONS
Insert the front towel bars into the holes in the legs,
‰
being sure to engage the towel bars in the O-rings in
the legs.
Insert legs into holes in floor.
‰
Tilt the legs away from the wall so that a helper can
‰
install the side rails into the legs, being sure to engage
the side rails in the O-rings in the legs.
Tilt the legs back to a vertical position, while a helper
‰
guides the side rails into the side rail mounting brack-
ets, being sure to engage the side rails in the O-rings in
the side rail mounting brackets.
Adjust the leg height adjustment pads so that the top of
‰
the legs are level with each other.
Place the console top upside down to install the lavatory.
‰
NOTe: When installing the lavatory, use the clips provided with the lavatory
and the hardware provided with the console top.
Install the lavatory.
‰
With a partner, pick up the console top and align the holes on the bot-
‰
tom of the console top with the holes on the top of the wall bracket.
Verify that the console top is level and re-adjust the height adjustment
‰
pads if necessary.
Apply silicone sealant where the leg height adjustment pads meet the
‰
console top to stabilize it.
Thread the supplied washer and Phillips head screw through the
‰
bracket into the console top and secure. Do not overtighten.
1095725-2-A
Page 4 of 5
3.
ASSeMBLe THe CONSOLe TABLe LeGS
4.
INSTALL THe CONSOLe TOP
Inigo Console Table
Side Rail
Mounting Bracket
Leg Height
Adjustment Pad
Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
Side Rails
Leg Height
Adjustment Pad
Front Towel
Bars
Apply silicone
sealant
Advertisement
