Advertisement
INSTALLATION INSTRUCTIONS
Rough-in the water supply lines and the drain piping.
‰
Install a minimum of a 2x6 as a wall brace to provide support for
‰
the wall bracket. The brace should be the same length as the
console table, 36" and should be positioned 32" from the finished
floor to the top edge of the board. The center of the wall brace
should be in-line with the drain outlet.
Finish the wall.
‰
Mark the centerline on the floor and the wall.
‰
Mark the anchor holes on the wall for the side rail mounting
‰
brackets.
Mark the anchor holes for the console table mounting bracket on
‰
the wall by holding the bracket up to the finished wall so that the
center of the bracket lines up with the centerline. Mark the loca-
tion of the anchor holes with a pencil.
Mark the location of the holes on the floor for the feet anchors.
‰
Drill two holes 5/16" D. x 1/2" deep, in the finished floor for each
‰
foot anchor. The holes should be 21-1/4" from the wall and 16"
from the centerline.
Install the side rail mounting brackets to the finished wall
‰
with fasteners suitable for your wall type.
Install the console table mounting bracket to the finished
‰
wall with fasteners suitable for your wall type.
Verify the table mounting bracket is level.
‰
1095725-2-A
Page 3 of 5
1.
PRePARe THe SITe
2.
INSTALL THe MOUNTING BRACKeTS
Inigo Console Table
Wall Bracing
(2x6 minimum)
Finished
Floor
Side Rail
Bracket Anchor
Holes
31-13/16"
26-23/32"
31-1/2"
21-1/4"
Console Table
Mounting Bracket
Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
Finished
Wall
34"
C L
Console Table
Bracket Anchor
Holes
32-13/16"
Foot
Mark the
Anchor
anchor
Holes
holes.
C L
16"
Side Rail
Mounting Bracket
Advertisement
