Husqvarna WSC40 Workshop Manual page 23

ASSEMBLY
4. Replace the inlet pipe with a new one, if
needed. Apply yellow Loctite on the threads
of the new inlet pipe (A) as sealant. Screw the
new inlet pipe by hand into the gearbox.
5. Grease the threads in the Chain tension
adjustment knob (B), 20 mm below the edge to
the water hose connection.
6. Apply yellow Loctite on the threads of the water
hose connection (C).
7. Tighten the water hose connection with a
tightening torque of 24 Nm.
REMOVE THE GEAR BOX
B
C
INSTALL A NEW INLET PIPE
Repair instructions
A
23
English -