Sureguard Pro-Tech 5 User Instructions page 10

Advanced User Features
The cog icon on the solar panel is a Touch Switch. When you switch the Energiser ON, it is
active for the first 45 seconds. During this time, you can customise the operation of the
Energiser.
How to Enter the Advanced Features Mode
1. Switch the Energiser OFF. Wait
10 seconds. Switch ON.
2. Wait until the FENCE LED stops
flashing BLUE.
3. Touch the cog icon for about 1-
second until you see both LED
lights glow BLUE.
TIP: Touch lightly, don't press
hard. If your finger is small, use
your thumb.
4. As soon as you see both LEDs glow BLUE, remove your finger off the cog.
5. Wait until both BLUE LEDs go OFF.
6. Momentarily tap the cog icon the number of times required to match the function you
are trying to enter (as per the list below). TIP: You'll find the Touch Switch responds
better when you press and release by moving your finger at least 2cm away from the
cog.
❖ Touch once (Function #1):
Reset all functions
1/LED's light in sequence RED-GREEN-BLUE.
2/ Alarm Buzzer sounds.
3/ Solar panel, in sunlight, is linked to the POWER LED. It will flicker BLUE to verify power
is going into the battery. NOTE: If the battery is fully charged, the POWER LED will not
flicker BLUE. This is normal but you can run the Energiser overnight and recheck this.
4/ Energiser reboots automatically after 20 seconds.
❖ Touch twice (Function #2):
Timer is switched OFF. Energiser will operate
❖ Touch 3 times:
Timer is switched onto
15-minutes after sunset. During the day the Energiser is OFF, and the FENCE LED glows
BLUE. NOTE: The Alarm Buzzer is always controlled by Function #5, #6 or #7.
❖ Touch 4 times:
Timer is switched onto
to factory default and performs the following hardware tests:
Night Mode. The Energiser will operate at night, starting about
Day Mode & will only operate during the day, starting about 15
24-hours a day. (Factory default setting).
10