Table of Contents
Advertisement
Quick Links
S
WITCH
S
CANNER
Instruction Manual
The World at a Touch
ADAPTIVATION
I N C O R P O R A T E D
2225 W. 50th St., Suite 100
Sioux Falls, SD 57105
800-723-2783
www.adaptivation.com
PRINTED IN U.S.A.
Contents
INTRODUCTION ..................................................................... 3
PREVIEW .................................................................................. 3
QUICK START GUIDE ............................................................ 5
BATTERY INSTALLATION .................................................... 7
GETTING STARTED ............................................................... 7
DIRECT SELECT SWITCHES ............................................... 7
PROGRAMMING ..................................................................... 8
EXTERNAL SCANNING CUE ACCESS .............................. 13
TROUBLESHOOTING .......................................................... 13
OVERLAY TEMPLATE ......................................................... 15
WARRANTY ............................................................................ 16
Advertisement
Table of Contents
Related Manuals for Adaptivation SWITCH SCANNER
Summary of Contents for Adaptivation SWITCH SCANNER
-
Page 1: Table Of Contents
Instruction Manual TROUBLESHOOTING ............13 OVERLAY TEMPLATE ............15 WARRANTY ................16 The World at a Touch ADAPTIVATION I N C O R P O R A T E D 2225 W. 50th St., Suite 100 Sioux Falls, SD 57105 800-723-2783 www.adaptivation.com... -
Page 2: Introduction
Preview Seconds/ Minutes Your Switch Scanner has the ability to access up to six objects such as battery- Switch operated toys or up to six messages from voice output communication aids (VOCA). The battery-operated toys will need to be switch-adapted using Adaptivation’s Battery Interrupters. -
Page 3: Quick Start Guide
What happens next is determined by how that channel has The purpose of this quick start guide is to allow you to use your Switch Scanner been programmed to function. If it is channels one or two, then the toy will go on as soon as possible using the preset factory settings. -
Page 4: Battery Installation
Insert 4 AAA alkaline batteries into the battery compartment located on the back The full power of your Switch Scanner is realized when using it with scanning. side of the Switch Scanner. Use a small Phillips screwdriver to remove the Note that there are no built-in switches for scanning. - Page 5 Turning the Switch Scanner off, or pressing any switch or button on or plugged into your Switch Scanner will turn the channel off. If SCAN(INV) is pressed to stop a scan, the selected channel LAST: The Switch Scanner will begin scanning with the last previously acti- will remain on for as long as SCAN(INV) continues to be pressed.
- Page 6 Switch Mode them off. The Switch Scanner can be set to scan from two to six channels. All six chan- Note: When setting timing modes, adjust the desired amount of time before nels are independently capable of operating in the following modes: pressing the PROGRAM button.
-
Page 7: External Scanning Cue Access
Scanning Overlay from Adaptivation are available to plug into the four extra Latched, Timed, or Alarm. ports on the Switch Scanner. By plugging in the large LEDs, this may assist in- dividuals in scanning. The LEDs can be placed (usually with Velcro) on the de- Problem: The batteries seem to wear out too quickly. -
Page 8: Warranty
1(800)-723-2783, (605) 335-4445, Fax: (605) 335-4446, e-mail: info@adaptivation.com, Web Page: www.adaptivation.com Please insure your Switch Scanner is clean before returning it to Adaptivation for service. This is not a medical device. It should not be used where incorrect or faulty operation could reasonably be expected to result in injury or worse! This is not a medical device.
Need help?
Do you have a question about the SWITCH SCANNER and is the answer not in the manual?
Questions and answers