Advertisement
Quick Links
Advertisement
Related Manuals for Rehau RE.GUARD
Summary of Contents for Rehau RE.GUARD
- Page 1 RE.GUARD Water Sensor EN Operation manual...
- Page 2 RE.GUARD Water Sensor is a wireless sensor powered by ER14250 battery. It is used for detecting water overflowing. It can communicate with an associated Z-Wave device, such as RE.GUARD Water Control, Siren, Smart Switch, etc. The features list: 1. Z-Wave Plus certified for wide compatibility (500 serials product).
- Page 3 01.02 Spezifikation Power supply: ER14250 3.6 V Battery Storage environment: –20 °C – +60 °C 0 % – 90 % r.H. Operational temperature: ±0 °C – +40 °C Radio protocol: Z-Wave plus Radio frequency: 868.42MHz (EU version) 869 MHz (RU version) Range: More than 100 m outdoors up to 30 m indoors (depending on building...
- Page 4 2. Remove the battery blocker or insert a battery ER14250 3.6V Battery Blocker Note: When powered, the device will indicate Z-Wave status with LED: 1. Blink slowly: the device is not added to any Z-Wave network. 2. Solid: the device is already added to the Z-Wave network. 3.
-
Page 5: Installation
03 Installation: Water Sensor should not be mounted directly on or near metal framing or other large metallic objects since metal objects may weaken the radio signal strength. After “activation” process, the sensor can work without any installation. Furthermore, you can use the extension probe to fix sensor body. To install with extension probe, follow the steps: 1. - Page 6 2. Place the device within the direct range of your Z-Wave controller, e.g. RE.HUB Gateway. 3. Set the main controller’s adding mode (see the controller’s manual), e.g. via RE.GUARD App. 4. Press the Z-button once or press it briefly three times, the LED indi- cator should blink fast in blue.
- Page 7 2. Place the device within the direct range of your Z-Wave controller, e.g. RE.HUB Gateway. 3. Set the main controller remove mode (see the controller’s manual), e.g. via RE.GUARD App. 4. Press the Z-button briefly three times, the LED indicator should blink fast in orange.
- Page 8 07 WAKE-UP Wake-up-interval: Available settings: 0-2678400 Default setting: 0, setting via RE.GUARD App: 86400 Defining a time period by which the Water Sensor sends a wake up notification command frame to communicate with the assigned device, update parameters, update software, detects battery level.
-
Page 9: Advanced Configuration
08 Advanced configuration Water Sensor offers a wide variety of advanced configuration settings. Below parameters can be accessed from main controllers configuration interface. Parameter No. 14 Enable/Disable BASIC SET command Water Sensor can send BASIC SET command to nodes associated with group 2. - Page 10 Parameter No. 19 Temperature report time (10 minutes) Parameter No.19 Temperature report time (10 minutes) The sensor mea- sures the temperature every ten minutes, change of 1 degree Celsius will be reported. By default, it must report at least once a day. Available settings: 3 –...
-
Page 11: Further Information
09 Simplified declaration of EU conformity REHAU AG+Co hereby declares that the device complies with the basic requirements and relevant provisions of the 2014/30/EU, 2011/65/EU and 2014/53/EU Directives. The complete text of the Declaration of Conformity is available at the following Internet address: www.rehau.de/zertifikate-hochbau...