Detergent - Panasonic NA-F80VS7 Operating & Installation Instructions Manual

Detergent

Put in detergent, bleach and
softener according to the water
level displayed.
● Follow the instructions on each package.
■
Liquid detergent/bleach
6
■
Powder detergent/bleach
■
Softener
● Turn the tub by
hand if it is difficult
to put in the softener
inlet. (P. 10)
Putting in detergent
● When powdered detergent is poorly soluble, dissolve
in warm water before putting in.
• Put in the detergent little
Water of approx. 30 ºC
(approx. 5 L)
● If there are many thick or large clothes (jeans,
sheets, ect.) in the tub, the detergent may remain
undissolved. Dissolve the detergent according to the
above method, or reduce the amount of laundry.
● The level of foaming depends on conditions such
as load size, degree of soiling, detergent type, and
water hardness.
Putting in bleach
● Do not use chlorine bleach for coloured clothes to
prevent loss of colour.
● After using chlorine bleach, wash the tub with the
VỆ SINH LỒNG GIẶT (Tub Hygiene) program
10
without bleach. (P. 11)
● Do not use bleach for the
program.
Putting in softener
● Softener is automatically released during the final
rinse process.
● To add softener during operation, press "Pause"
first.
● Up to about 40 ml can be added. To add more
softener, use the GIẶT NGÂM NƯỚC XẢ
4
(Fragrance) program.
● When using
concentrated softener,
dilute it with water
before putting it in.
NOTE
● Softener cannot be used with the
NƯỚC (Water Save) program.
● Do not use separated or solidified softener.
● If "Pause" is pressed during spin cycle, the softener
will be added too early and its effectiveness will
decrease.
● The softener will not be added automatically if not
put in by the time wash process is complete.
by little while stirring to
prevent it from getting
hard or remaining in a
powder state.
GIẶT NHẸ (Delicate)
2
Concentrated
softener
Water Water
TIẾT KIỆM
8