3.1.4.2. Cable Length Settings
This page is used to individually set the simulation cable length for each module. There are three
modes to choose, which are Bypass, Short and 100m, respectively regarding to short by relay, 1~3
meters and 100 meters. The page is shown as follows.
Click Apply to make your settings here effective.
3.1.4.3. Characteristic Chart
This page is used to view the characteristic chart of a certain module. The page is shown as follows.
Slot ID: select the slot ID of the module to see its characteristic chart.
Line: select the wire pairs. There are four pairs (Pair-12, Pair-36, Pair-45, and Pair-78) and you can also
choose to display all the four pairs (All-Pair).
In the chart, the x-axis denotes frequencies (64 points in total but 32 points for IE8) while the Y-axis
denotes the decibel values.
32