1. Manuals
  2. Brands
  3. BendPak Manuals
  4. Desktop
  5. WSA-100
  6. Quick start manual

BendPak WSA-100 Quick Start Manual

Utility station
Hide thumbs
1
2
3
4
Table of Contents

Advertisement

Quick Links

Download this manual
WSA-100 Utility Station
The WSA-100 Utility Station (SKU 5210438) conveniently adds air and electric outlets to many BendPak lifts.
This WSA-100 Utility Station can be used with the following BendPak Lifts:
Four Post Lifts:
•
HD Series (HD-7/9/14)
•
HDS Series (HDS-14/18/27/35/40)
•
HDSO-14 Series
•
D4-12 Model
The following drawing shows the main components of the WSA-100 Utility Station.
⚠ WARNING
California Proposition 65: This product can expose you to chemicals including styrene and vinyl
chloride, which are on the list of over 900 chemicals identified by the State of California to cause
cancer, birth defects, or other reproductive harm. Always use this product in accordance with
BendPak's instructions. For more information, visit www.p65warnings.ca.gov.
Copyright © 2021 BendPak Inc. All rights reserved.
Two-Post Lifts:
•
GP-7 Series
•
10AP Series
•
XPR Series (XPR-9/10/12/15/18)
•
D2 Series (D2-8/10/12/15)
Quick Start Guide
P/N 5900095 — Rev. B — Sept. 2021
1645 Lemonwood Drive
Santa Paula, CA, 93060 USA

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WSA-100 and is the answer not in the manual?

Questions and answers

Related Manuals for BendPak WSA-100

Summary of Contents for BendPak WSA-100

  • Page 1 Quick Start Guide P/N 5900095 — Rev. B — Sept. 2021 The WSA-100 Utility Station (SKU 5210438) conveniently adds air and electric outlets to many BendPak lifts. This WSA-100 Utility Station can be used with the following BendPak Lifts: Four Post Lifts: Two-Post Lifts: •...
  • Page 2 The main components of the WSA-100 are: certified • Four outlets. Two have GFCI, two do not. Maximum current 20 Amps. Have a licensed, 110 VAC electrician connect outlets to 1 phase, 60 Hz, 110 VAC using suitable conduit (not supplied). Duplex receptacle...
  • Page 3 Two-Post Lifts. Use one of the bare sides of the Power Post. The equipment must be positioned a 18 in. / 457 mm from the ground. Use the WSA-100 as a guide to mark the four (4) hole locations on the Lift Post, set the Mounting Bracket aside, then drill 11/32”...
  • Page 4 The following illustrations show how to connect the WSA-100 to a BendPak Four-Post Lift. For Light/Medium Duty Four-Post Lifts: For Heavy Duty Four-Post Lifts: 4 of 4 WSA-100 Utility Station QSG P/N 5900095 – Rev. B – September 2021...

This manual is also suitable for:

5210438

Table of Contents