Quick Set-Up; Quick Set-Up: Receiver; Quick Set-Up: Transmitter; Quick Set-Up: Sys Tem Op Er A Tion - Electro-Voice Telex RE-1 Operating Instructions Manual

Quick Set-up: Receiver

1. Do not connect the receiver to any other equip ment yet!
2. Connect the two an tennas to the receiver.
3. Plug the power supply into the back of the re ceiver and
into an out let
4. Press the POWER switch. Dis play will light up, show
information and software revision numbers for about 3
seconds and then display the main op erating screen.
5. Press the MENU button twice to dis play the ClearScan
op tion screen.
6. With the CLEARSCAN ALL line indicated press SET.
7. ClearScan TM re turns the clear est group. Press SET again.
8. ClearScan TM re turns the clearest chan nel in that group.
Press SET again.
9. The display will return to the main op erating screen with
the clear est chan nel in the clear est group as signed.
10. Turn the re ceiver off and con nect the mixer or other au dio
system to the re ceiver XLR Mic Level Connector or the ¼
inch Line Level Jack.
11. Set the audio mixer or other system in put level to mini-
mum.
12. Press the Power switch button in again.
Receiver "Quick Set-up" is com plete.

Quick set-up: Transmitter

1. With the Power Switch on the transmitter OFF, in stall a
fresh al kaline battery into the transmitter.
2. Place the transmitter Power Switch to the ON position.
3. The Red Low Bat tery Light near the dis play will flash on
and then off. The display will also come on briefly, dis -
play ing bat tery level.
4. The screen will stop at the GP (Group) and CH (Channel)
screen. Press the SET but ton once and the Group number
will flash.
5. Use the up and down arrows to change the Group number
to match the channel number displayed on the re ceiver.
Press SET and the Chan nel Number will flash.
6. Use the up and down arrow but tons to change the Channel
to match the receiver. Press Set and flashing stops. The
channel is now set.
7. If you are us ing a bodypack transmitter, plug the mi cro-
phone into the transmitter con nector. If us ing a guitar,
TM
place the In strument/Mic switch un der the battery door in
the Instrument po sition and plug the cord into the transmit-
ter and gui tar.
Transmitter "Quick Set-up" is com plete.

Quick set-up: Sys tem Op er a tion

1. With the transmitter and re ceiver on, monitor the
CSR-1000 Re ceiver main dis play screen. Note that the RF
(1-100) Bar graph should in dicate near the 100 mark. The
AF Bar should show very little, if any, in dication un til you
talk or sing into the microphone. Ad just the transmitter
gain control if nec essary to cause the AF Bar Graph to
peak near -6 to -3 but not over +3 for best per formance.
2. Set the mixer or other system gain.
3. Talk or sing into the microphone or play the instrument at
a nor mal volume. You should hear au dio coming out of the
sys tem.
4. If us ing the un balanced 1/4" output, you may have to ad-
just the gain (via the control next to the connector on the
back panel) to match the level found when singing or play-
ing with a wired con nection.
"Quick Set-up" is now complete.
Please enjoy your RE-1 system.
1-1
S
ection
1

Quick Set-Up