Pocketbook РВ 903 Quick Firmware Installation Manual

WARNING! Firmware Update - important operation, during which control program of e-book will
be changed. In case of improper execution, control program may be damaged, causing loss of device
efficiency and referring to the service center. Try to perform the upgrade procedure strictly following
the instructions.
To update the device software you can download new firmware from our website:
int.com
Select your location, the model of your device in the Products section, click the
right software and documentation link to enter the section of the software update.
Download to PC the latest firmware from the firmware section.
Then you can install the firmware on the device, follow these steps:
1. Unpack the archive content at external micro SD card or root folder of the internal memory.
2. Turn off PocketBook Pro pressing the "On / Off. "
3. Turn on PocketBook Pro with inserted Micro SD-card by pressing the "On / Off";
4. While the device is turning on, press and hold buttons: paging "Back" and paging "Next" until the
message «Firmware update ...» is appeared;
5. Attention! Follow the instructions on the screen.
Note: The device can be reloaded during update process;
6. When the inscription « Update is OK. Now please reset device » appears on the screen, switch on the
device, the firmware installation is completed.
Note: The firmware version can be checked in "Settings»
Note: If the firmware file is located in the root folder of your device, it has a higher priority for the upgrade
procedure than the file which is located at the SD card.

Troubleshooting

Error message
No update image found
Update image is corrupted
or Image is empty
File reading error
Error: The device is
installed another version
of the firmware.
After checking, it was found
that the firmware version of
the device has not been
Central Office, Ukraine, Kiev, Tampere Street, 5
Tel.: +38 044 501 06 47, Fax.: +38 044 501 06 45
http://www.pocketbook-int.com,
Quick Firmware Installation Guide
РВ 903
Model
⇨
Reason
File SWUPDATE.BIN is not
found at the SD card.
SWUPDATE.BIN file is
corrupted or there is no
space at the SD card.
SD card reading error
The internal
memory contains the
old
version of firmware file.
One of the requirements
of the firmware installing
program was not
implemented. See p 5.
«Device Information"
Try to format the SD card (previously saving all the
information on your hard drive) and copy firmware update
file to the formatted card. In case the error is repeated,
try to upgrade using another SD card.
Delete unnecessary files from the card and copy
the file SWUPDATE.BIN again. Try to download the
firmware from the site www.pocketbook-int.com. In case
the error is repeated, try to upgrade using another SD card.
Try to upgrade firmware using another SD card.
Remove the old firmware file from the root
of internal memory.
Start installing the firmware again, and carefully and
on time, follow the instructions of the program. For
example: "Plug in" and "Press the center button"
info@pocketbook.com.ua
www.pocketbook-
Repair